JBL SYNTHESIS SDP-40 - Manual (Page 28)

Basic Operation
JBL
2-12
To select a parameter setting with a horizontal graph:
1. When the horizontal graph appears, press the and
arrow buttons to increase and decrease the setting in designated
increments. The current setting appears at the right of the
parameter name on the on-screen and front panel displays.
2. When the desired adjustments have been made, press the
arrow button to select the setting and close the horizontal
graph.
COMMAND BANK ACTIVATION
Remote control buttons perform different commands depending
on whether the Main Zone, Zone 2, Record Zone, or Shift
command bank is activated. Pressing and releasing a remote
control command bank selection button – MAIN, ZONE, REC, or
SHIFT – activates the corresponding command bank. The selected
command bank remains activated until another command bank is
activated.
The command bank selection buttons themselves do not send
commands to the SDP-40. When pressed and released, these
buttons activate the corresponding command bank.
Note:
Remote control command bank selection buttons
should not be pressed and held.
To activate a command bank:
1. Press and release a command bank selection button to activate
the desired command bank.
2. Press a remote control button to send the associated command
to the SDP-40. The command matrix that begins on the next
page indicates the commands remote control buttons perform
when each command bank is activated.
The ON-SCREEN DISPLAY menu REMOTE STATE parameter controls
the remote control command bank indicator that appears on the
on-screen display. When the REMOTE STATE parameter is set to
ON, a command bank indicator appears in the top-right corner of
the on-screen display to indicate the last command bank from
which the SDP-40 received a command. When the REMOTE STATE
parameter is set to OFF, no command bank indicator appears on
the on-screen display.
A "Z" appears when a command from the Zone 2 command bank
was received last. An "R" appears when a command from the
Record Zone command bank was received last. An "S" appears
when a command from the Shift command bank was received last.
No letter appears when a command from the Main Zone command
bank was received last.
COMMAND MATRIX
The command matrix that begins on the next page indicates the
commands remote control buttons perform when each command
bank is activated. The numbers in the SDP-40 remote control
illustrations that also begin on the next page correspond with the
numbered items in the matrix.