JBL SYNTHESIS SDP-40 - Manual (Page 67)

SETUP
SDP-40
3-27
When a SYNTHESIS 7CH speaker setup is selected, the FRONT L/R
parameter cannot be adjusted. The SDP-40 automatically applies a
80Hz crossover point to the Front L/R output connectors.
CENTER FULL, 30 to 120Hz, THX 80Hz, NONE
Assigns a crossover point for the Main Zone audio output
connector labeled Center.
When a custom speaker setup is selected, the CENTER parameter
opens the CENTER SPEAKER menu shown on the previous page,
which can be used to select a crossover point for the Center output
connector.
• Select FULL to send a full-range signal to the center speaker.
Otherwise, select the crossover point closest to the low-
frequency rating of the center speaker.
• Select NONE if the speaker setup does not include a center
speaker. The SDP-40 will redirect center channel signals to the
Front L/R output connectors – unless the 5.1a BYPASS listening
mode is activated. In this instance, configure the speaker setup
with the associated DVD-A/SACD player to redirect center
channel signals.
When a SYNTHESIS 7CH speaker setup is selected, the CENTER
parameter cannot be adjusted. The SDP-40 automatically applies
an 80Hz crossover point to the Center output connector.
SYNTHESIS 7CH SETUP SET CROSSOVERS SPEAKERS SETUP
CENTER CUSTOM SETUP SET CROSSOVERS SPEAKERS SETUP
SYNTHESIS 7CH SETUP SET CROSSOVERS SPEAKERS SETUP SIDE L/R FULL, 30 to 120Hz, THX 80Hz, NONE
Assigns a crossover point for the Main Zone audio output
connectors labeled Side L/R.
When a custom speaker setup is selected, the SIDE L/R parameter
opens the SIDE L/R SPEAKERS menu shown on the previous page,
which can be used to select a crossover point for the Side L/R
output connectors.
• Select FULL to send a full-range signal to the side speakers.
Otherwise, select the crossover point closest to the low-
frequency rating of the side speakers.
• Select NONE if the speaker setup does not include side
speakers. The SDP-40 will redirect side channel signals to the
Rear L/R output connectors. If the REAR L/R parameter is also
set to NONE, the SDP-40 will redirect surround channel signals
to the Front L/R output connectors.
Note:
When the SIDE L/R parameter is set to NONE, Dolby
Digital Surround EX, THX Ultra2, THX Surround EX,
and dts-ES decoding are not available. The ASA
parameter is also not available.
When a SYNTHESIS 7CH speaker setup is selected, the SIDE L/R
parameter cannot be adjusted. The SDP-40 automatically applies a
80Hz crossover point to the Side L/R output connectors.
. . . Setting Crossover Points continues on page 3-28
SYNTHESIS 7CH SETUP SET CROSSOVERS SPEAKERS SETUP
SIDE L/R CUSTOM SETUP SET CROSSOVERS SPEAKERS SETUP