JBL SYNTHESIS SDP-40 - Manual (Page 115)

5.1-Channel
Dolby Digital
5.1-Channel
THX Surround EX
Dolby Digital (Flagged)
5.1-Channel
THX Surround EX
Dolby Digital (Non-Flagged)
MODE ADJUST
SDP-40
5-17
5.1 ULTRA2, 5.1 SurEX, & 5.1
Listening mode name differs depending on the encoding present
in the input source, the SURROUND EX parameter setting, and the
speaker setup. The table below indicates the conditions in which
THX Ultra2 and THX Surround EX decoding are engaged.
• The 5.1 ULTRA2 listening mode is available when THX
Ultra2 decoding is engaged.
• THX Ultra2 decoding is engaged when the SURROUND EX
parameter is set to OFF or when the SURROUND EX parameter
is set to AUTO and a non-flagged 5.1-channel Dolby Digital
source with or without THX Surround EX encoding is detected.
• The 5.1 SurEX listening mode is available when THX
Surround EX decoding is engaged.
• THX Surround EX decoding is engaged when the SURROUND
EX parameter is set to ON or when the SURROUND EX
parameter is set to AUTO and a flagged 5.1-channel Dolby
Digital source with THX Surround EX encoding is detected.
5.1 @** OR 5.1 @** SurEX OR 5.1 @** ULTRA2 MODE ADJUST
• The 5.1 Ultra2 and 5.1 SurEX listening modes are not
available unless both side and rear speakers are present.
• The 5.1 listening mode is available when neither THX
Ultra2 nor THX Surround EX decoding is engaged.
Note:
The SDP-40 cannot automatically detect THX
Surround EX encoding in non-flagged 5.1-channel
Dolby Digital sources. A non-flagged input source
does not include information in the input signal that
identifies THX Surround EX encoding.
Parameter Setting
Input Source
5.1 ULTRA2 5.1 ULTRA2
5.1 SurEX
5.1 ULTRA2
5.1 ULTRA2 5.1 ULTRA2 SURROUND EX: AUTO
SURROUND EX: ON
SURROUND EX: OFF
5.1 SurEX 5.1 SurEX
5.1 SurEX
. . . 5.1 ULTRA2, 5.1 SurEX, & 5.1 continues on page 5-18