JBL SYNTHESIS SDP-40 - Manual (Page 65)

SYNTHESIS 7CH SETUP Menu
Default Setting Default Setting Possible Settings Possible Settings
CUSTOM SETUP Menu
Parameter
SETUP
SDP-40
3-25
Speaker Setup Parameters
SYNTHESIS 7CH SETUP SET CROSSOVERS SPEAKERS SETUP OR CUSTOM SETUP SET CROSSOVERS SPEAKERS SETUP
The table below indicates the speaker setup parameters that can be
used to configure the Main Zone audio output connectors for the
desired speaker setup. These parameters appear on the CUSTOM
and SYNTHESIS 7CH SETUP menus. Speaker setup parameters perform the same function regardless of
which speaker setup is selected. When a parameter setting is
adjusted on one menu, the corresponding parameter setting is
automatically adjusted on the other menu. For instance, when a
SYNTHESIS 7CH speaker setup is selected, the speaker setup
parameters on the CUSTOM SETUP menu are also set to 80Hz.
FRONT L/R*
CENTER*
SIDE L/R*
REAR L/R
SUB L/R*
SUB XOVER*
LFE*
ULTRA2 SUB
BGC
ASA
80Hz 80Hz 80Hz
80Hz
80Hz
80Hz
80Hz, NONE
80Hz
80Hz
80Hz
80Hz 80 Hz
80Hz
80Hz
80Hz
80Hz
80Hz
ON ON
OFF OFF
N/A† N/A†
APART APART
80Hz
FULL, 30 to 120Hz, THX 80Hz
FULL, 30 to 120Hz, THX 80Hz
ON, OFF ON, OFF
ON, OFF
ON, OFF
ON, OFF
ON, OFF
APART, CLOSE, TOGETHER APART, CLOSE, TOGETHER
FULL, 30 to 120Hz, THX 80Hz, NONE
FULL, 30 to 120Hz, THX 80Hz, NONE
FULL, 30 to 120Hz, THX 80Hz, NONE
MONO, STEREO, NONE
* These parameters cannot be adjusted on the SYNTHESIS 7CH SETUP menu.
† When the ULTRA2 SUB parameter is set to OFF, the BGC parameter is not available (N/A). . . . Setting Crossover Points continues on page 3-26