JBL AV1 - Manual (Page 32)

Basic Operation
JBL Performance
2-14
S1 + DOLBY
When the Shift command bank is activated, pressing the remote
control DOLBY button while a 5.1-channel Dolby Digital input
source is present activates the DOLBY DIGITAL EX or DOLBY DIGI-
TAL listening mode. Subsequent presses toggle the EX DECODING
parameter, cycling through the AUTO, ON and OFF settings.
S1 + DTS
When the Shift command bank is activated, pressing the remote
control DTS button while a DTS(-ES) input source is present toggles
the ES DECODING parameter, cycling through the AUTO, ON and
OFF settings.
S1 + THX
When the Shift command bank is activated, pressing the remote
control THX button while a 5.1-channel Dolby Digital input source
is present activates the 5.1 THX, 5.1 THX ULTRA2 or 5.1 THX SurEX
listening mode. See page 5-17 for more information.
TWO-LINE STATUS
The two-line status shown at the right indi-
cates the current input, listening mode, input
source and volume level. The two-line status
appears in the on-screen and front-panel displays when the AV1
detects a status change.
The ON-SCREEN DISPLAY menu STATUS parameter controlls the
length of time the two-line status appears in the on-screen display. The
ON-SCREEN DISPLAY menu POSITION parameter controls the posi-
tion of the two-line status on the on-screen display.
Note:
When the display device is connected to a component video output
connector and the ADVANCED menu COMPONENT OSD parameter is
set to OFF, the display device does not show the on-screen display,
including the two-line status.
STATUS MENUS
Activate the Shift command bank and press the remote control Stat
button to open the STATUS menu for the current input source. The
STATUS menu contains parameters that provide information about the
current input source and listening mode. STATUS menus are available
for 2-channel, Dolby Digital, DTS(-ES) and analog input sources.
Unlike most other menus, STATUS menus cannot be opened by
selecting menu options. The remote control Shift, Stat command
must be performed.
To open and navigate the STATUS menu for the current input
source:
1. Press and hold the remote control S1 button.
2. While holding the S1 button, press the remote control Stat
button. The first page of the STATUS menu for the current
input source appears in the on-screen and front-panel displays.
DVD1 D VOL
FILM -34dB