JBL AV1 - Manual (Page 107)

AV1
Mode Adjust
5-9
MUSIC
• Designed for playback of matrix-encoded digital stereo music
sources.
• Derives six channels when both side and rear speakers are
present (rear channels will be in parallel). Derives five channels
when only side or rear speakers are present. The subwoofer
channel is generated through bass management in the AV1.
See “Listening Mode Menu Option & Parameter Descriptions” on page 5-29 for detailed
descriptions
.
Please note the following about DTS Neo:6 listening mode
activation:
• The DTS Neo:6 listening modes cannot be assigned as the
preferred listening mode for 2-channel sources. However,
when the 2-CH parameter is set to USE LAST, the AV1 will
automatically activate a DTS Neo:6 listening mode if a DTS
Neo:6 listening mode was activated the last time a 2-channel
source was present.
• The AV1 will not automatically activate the DTS Neo:6 lis-
tening modes unless a 44.1kHz or 48kHz PCM digital source
is present. The DTS Neo:6 listening modes are not available
with 88.2kHz or 96kHz, Dolby Digital, or analog sources.
• The DTS Neo:6 MUSIC listening mode can be activated with
the front-panel or remote control Mode and
buttons.
The DTS Neo:6 CIN listening mode can also be activated with
the remote control DTS button when a 2-channel input
source is present.
+
• Designed for playback of matrix-encoded digital stereo film
sources.
• Applies THX re-equalization to simulate high-frequency
rolloffs that occur in movie theaters. Most films are mixed for
movie theaters, and might sound too bright when played
back in home theaters without re-equalization.
See “Listening Mode Menu Option & Parameter Descriptions” on page 5-29 for detailed
descriptions
.
Option/Parameter
OUTPUT LEVELS
CUSTOM
MODE ADJUST MUSIC
Option/Parameter Default Setting Possible Settings
RE-EQUALIZER ON ON, OFF
OUTPUT LEVELS -- --
CUSTOM -- --
MODE ADJUST +