JBL AV1 - Manual (Page 151)

AV1
Appendix
A-13
2CH STATUS
INPUT
MODE
INPUT TYPE
SAMPLE RATE
dB
0
-6
-15
-30
-45
R L
D STATUS
INPUT
MODE
CHANNELS
BIT RATE
dB
0
-6
-15
-30
-45
R L
EX ENCODING
PG1
C SL SR LFE
STATUS
INPUT
MODE
CHANNELS
BIT RATE
dB
0
-6
-15
-30
-45
R L
ENCODING
PG1
C SL SR LFE
STATUS
WORD LENGTH
SAMPLE RATE
PG2 5.1a BYPASS STATUS
INPUT
MODE
INPUT TYPE
2CH BYPASS STATUS
INPUT
MODE
INPUT TYPE
DIGITAL STATUS
INPUT
MODE
INPUT TYPE
SAMPLE RATE
SPEECH DETECT
ON
OFF
SOUND STAGE
FRONT 0 to15ms
SURROUND DLY
-5 to + 5dB
SURROUND MIX
500Hz to 20.0 kHz, OFF
SURR ROLLOFF
SUB LEVEL
OFF, -30 to +12dB
NEUTRAL
REAR
VOCAL ENHANCE
+6.0dB
+3.0dB
+6.0dB
SURROUND EX
AUTO
ON
OFF
STATUS PG2
SAMPLE RATE
2.0 ENCODING
DIALOG OFFSET
MIX ROOM
CENTER MIX LVL
SURR MIX LVL
FACTORY SETTINGS
EXIT
RESTORE DEFAULTS
FACTORY SETTINGS
HAVE BEEN RESTORED
PRESS ANY KEY
TO RESTART
Activating the AV1 while pressing and holding the
front-panel or remote control Mute button opens the
FACTORY SETTINGS menu shown below. Refer to
page 6-4 for more information.
When the Shift command bank is active, pressing the remote control Stat button opens the STATUS menu for
the current input source. This menu contains parameters that provide information about the current input
source and listening mode. STATUS menus are available for 2-channel, Dolby Digital, DTS(-ES), digital and
analog input sources. Refer to page 2-14 for more information.
STATUS menu parameters provide information about the current input source and listening mode. These
parameters cannot be adjusted. Refer to the STATUS Menu Parameter Descriptions section that begins on
page 2-19 for more information.