JBL AV1 - Manual (Page 17)

AV1
Getting Started
1-5
REMOTE CONTROL BATTERY INSTALLATION
The remote control requires two AA batteries. The batteries should be replaced as needed. Alkaline batteries, which last longer without leaking,
are recommended. When battery power is low, the remote control enters a low-voltage condition, preventing it from operating the AV1. When
this occurs, replace the batteries. Normal operation will resume when new batteries are installed.
To replace the remote control batteries:
1. Locate the battery compartment on the back of the remote control. Press the tab and lift the cover away from the remote control.
2. Remove old batteries (if applicable).
3. Observing the proper polarity, insert two AA batteries.
4. Align the cover over the battery compartment and gently press down until it snaps back into place.
5. Dispose of the old batteries (if applicable).