JBL AV1 - Manual (Page 24)

Basic Operation
JBL Performance
2-6
REMOTE CONTROL OVERVIEW
The AV1 remote control provides full operation of the AV1, including
commands such as menu navigation that are not available from the
front-panel. The command matrix that beginning on page 2-10 indi-
cates the commands remote control buttons perform when each
command bank is active. The numbered items in the matrix corre-
spond with the remote control illustrations on pages 2-10 to 2-13.
OPERATION CONSIDERATIONS
The following factors can improve or impede remote control
operation.
Note the following before operating the AV1 remote control:
• The remote control must be in line-of-sight with the front-
panel IR receiver. Eliminate obstructions between the remote
control and the IR receiver. The remote control may become
unreliable if strong sunlight or fluorescent light shines on the IR
receiver.
• For optimal performance, position the remote control at a 30
degree angle no more than 17 feet (5m) from the AV1. Placing
the AV1 inside a smoked glass cabinet will reduce the remote
control range.
• Remote controllers for different components can interfere with
one another. Avoid using remote controls for different compo-
nents at the same time.
• Remote control batteries should be replaced as needed. See
page 1-5 for battery installation instructions.
MENU NAVIGATION
Use the remote control Menu arrows to navigate the extensive
menu structure shown in the Appendix (A-5 to A-13). The table on
the previous page indicates the navigation functions remote con-
trol Menu arrows perform.
MAIN MENU
The MAIN MENU, shown to the right, repre-
sents the beginning of the menu structure.
Use the MAIN MENU to open the three main
menu branches: MODE ADJUST, AUDIO
CONTROLS, and SETUP. See Sections 3, 4,
and 5 for information about these menu branches.
MAIN MENU
MODE ADJUST
AUDIO CONTROLS
SETUP