Invacare XtraTM 1026793 - Manual (Page 53)

SECTION 8—WHEELS
Part No 1026793 53 Xtra™
Adjusting Quick-Release Axles
NOTE: For this procedure, refer to FIGURE 8.2.
1. Remove rear wheel and quick/quad-release axle from the wheelchair. Refer to
Removing/Installing Rear Wheels on page 51.
2. Depress detent pin in the quick-release axle and slide axle through the wheel hub.
3. Release detent pin ensuring that the locking pins are fully released.
4. Increase or decrease end play by adjusting the locknut on the end of the quick-release
axle.
ƽ WARNING
Make sure the detent pin and locking pins of the quick-release axle are fully released
BEFORE operating wheelchair.
Keep locking pins clean.
5. Reinstall rear wheel onto the wheelchair. Refer to Removing/Installing Rear Wheels
on page 51.
FIGURE 8.2 Adjusting Quick-Release Axles
Axle Mounting Plate
Locking Pins
Wheel Hub Quick-Release Axle
Detent Pin
Locknut