Invacare XtraTM 1026793 - Manual (Page 32)

SECTION 4—FRONT RIGGINGS
Xtra™ 32 Part No 1026793
Adjusting Adjustable Angle Flip-Up Footplates
ƽ WARNING
When determining the angle of the footplates, make sure the rear of the footplates
DO NOT interfere with the movement of the front casters. Otherwise, injury or
damage may occur.
NOTE: For this procedure, refer to FIGURE 4.7.
Depth Adjustment
1. Remove the two (2) flat screws and locknuts that secure footplate to the half clamp.
NOTE: Observe the angle of the footplate for reinstallation.
2. Move the footplate to one (1) of four (4) mounting positions.
NOTE: If desired depth is still not obtained, rotate the half clamp on the footplate hinge 180°.
3. Retighten the two (2) flat screws and locknuts.
NOTE: The setting for positioning the footplate on the half clamp may vary for each footplate.
4. Repeat STEPS 1-3 for opposite footplate, if desired.
Angle Adjustment
1. Loosen, but do not remove the adjustment screw in the half clamp.
2. Position the footplate to the necessary angle to accommodate the user (Detail "A"of
FIGURE 4.7).
3. Retighten the adjustment screw. Torque to over 90 inch-pounds, but no more than
300 inch-pounds.
4. Repeat steps 1-3 for opposite footplate, if desired.
FIGURE 4.7 Adjusting Adjustable Angle Flip-Up Footplates
90° Footrest Support
Locknuts
Footrest Support
Footplate
Adjustment Screw
Flat Screws
Half Clamp
Footplate
Footplate
Hinge
Detail "A" - Side View Of
Footplate and Footrest Support