Adjusting the back angle, Note: for this procedure, refer to figure 5.2, Reposition the back to the desired angle – Invacare XtraTM 1026793 User Manual

Page 35: Back cane, Figure 5.2 adjusting the back angle

SECTION 5—BACK

Part No 1026793

Xtra™

Adjusting the Back Angle

NOTE: For this procedure, refer to FIGURE 5.2.

NOTE: This procedure applies to adjustable angle backs only.

NOTE: The back adjusts to four (4) positions in five 5° degree increments from 0° to 15°.

1. Remove the two (2) back angle adjustment screws and locknuts.

2. Reposition the back to the desired angle.

3. Ensure the upper back angle mounting hole is aligned with one (1) of the four (4)

upper angle adjustment holes.

4. Install one (1) of the back angle adjustment screws through the upper back angle

mounting hole and the desired upper angle adjustment hole.

5. Install the remaining back angle adjustment screw through the lower back angle

mounting hole and the desired lower angle adjustment hole.

6. Secure each back angle adjustment screw with a locknut. Torque locknut to 80-100 in/

lbs.

FIGURE 5.2 Adjusting the Back Angle

Back Cane

Locknut

Lower Back

Angle Mounting

Hole

Back Angle

Adjustment

Screw

Upper Back Angle

Mounting Hole

Detail "A" - back

angle mounting holes

Upper

0°
5°