Installing elevating legrests, Note: for this procedure, refer to figure 4.3, Repeat steps 1-3 for the opposite legrest – Invacare XtraTM 1026793 User Manual

Page 30: Calfpad, Figure 4.3 installing elevating legrests, Raising/lowering elevating legrests, Release lever, Figure 4.4 raising/lowering elevating legrests

SECTION 4—FRONT RIGGINGS

Part No 1026793

Installing Elevating Legrests

NOTE: For this procedure, refer to FIGURE 4.3.

1. Insert the pivot tube into the legrest support and secure it with the bolt and nut.

2. Place legrest on the outside of the wheelchair and insert the mounting pin into the

mounting tube.

3. Rotate legrest toward the inside of the wheelchair until it locks in place.

NOTE: The footplate will be on the inside of the wheelchair when locked in place.

4. Repeat STEPS 1-3 for the opposite legrest.

5. After seated in wheelchair, adjust footrest to correct height by loosening nut and

sliding the pivot tube up or down until desired height is obtained.

6. To release the legrest, push the legrest release handle toward the inside of the

wheelchair and swing the legrest to the outside of the wheelchair.

FIGURE 4.3 Installing Elevating Legrests

Raising/Lowering Elevating Legrests

NOTE: For this procedure, refer to
FIGURE 4.4.

Perform one (1) of the following:

• Raising - Pull back on the release

lever until the leg is at the desired
height.

• Lowering - Support leg with one (1)

hand and push release lever
downward with other hand.

FIGURE 4.4 Raising/Lowering Elevating

Calfpad

Bolt and Nut

Footrest Assembly

Pivot Tube

Legrest Release Handle

Mounting Pin

Mounting Tube

Footplate

Release Lever