Rearmost mounting screws, Installing fabric clothing guards, Note: for this procedure, refer to figure 6.4 – Invacare XtraTM 1026793 User Manual
Page 40: Remove the seat cushion, if necessary, Reinstall the seat cushion, if necessary, Run the nylon cord through the cord lock, Fabric clothing guard, Figure 6.4 installing fabric clothing guards, Fer to figure 6.3, Figure 6.3
SECTION 6—SEAT
40
Part No 1026793
NOTE: Only Hook and Loop style seat positioning strap shown. Auto style seat positioning strap
attaches the same way.
FIGURE 6.3 Installing/Removing Seat Positioning Strap
Installing Fabric Clothing Guards
NOTE: For this procedure, refer to FIGURE 6.4.
1. Remove the seat cushion, if necessary.
2. Secure the fastening straps of the fabric
clothing guards to the fastening straps
on the seat upholstery.
3. Reinstall the seat cushion, if necessary.
4. Remove the two (2) phillips screws that
secure the back upholstery to the back
canes.
5. Position the D-rings on the mounting
holes in the back canes.
6. Reinstall the two (2) phillips screws.
Torque to 20-25 in./lbs.
7. Run the nylon cord evenly through the
two (2) D-rings.
8. Run the nylon cord through the cord
lock.
9. Push star wheel into cord lock to hold
the nylon cord in place.
10. Tie a knot in the nylon cord and cut the
excess, if desired.
FIGURE 6.4 Installing Fabric Clothing
Rearmost
Mounting Screws
Rear Edge of
Seat
Seat Rail
Seat Positioning
Strap Half
Seat Positioning
Strap Half
Fabric Clothing
Guard
Fastening
Strap
Seat Upholstery
Phillips Screw
D-ring
Card Lock
Phillips
Screw
D-ring
Star Wheel
Nylon Card