Intel SR9000MK4U User Manual
Page 69
Intel
®
Server System SR9000MK4U Product Guide
47
1. Remove the front bezel. For instructions, see
2. Push the hot-swap button for the memory box you want to remove. To cancel the
operation, push the button again within five seconds.
3. The power LED blinks; wait for all memory box LEDs to turn off. If the status LED
does stop blinking, shut down the system to replace the memory box.
4. Remove the memory box. For instructions, see
Warning: The memory box will be very hot. Do not touch any components on it.
5. Wait approximately 10 minutes to allow the memory box to cool before touching
any components on it.
6. Install, remove, or replace the DIMMs as necessary. See
.
7. Install the memory box. For instructions, see
, beginning with step 5. Then return to these steps.
8. Push the hot-swap button for the memory box. If the attention LED turns on after
pushing the button, see if the DIMM configuration is the same or different as the
configuration before you performed the hot-swap operation.
—
If the configuration is different, repeat steps 2 through step 6. Configure the
DIMMs. Continue this series of steps with step 7 above.
—
If the configuration is the same, a fault exists in DIMM or in the memory box.
Repeat these steps, using different DIMMs or a different memory box.
The power LED blinks, and then turns on solidly. The mirror LED blinks and then
it turns on solidly. Memory mirroring functions resume after the mirror LED is on
solidly.
9. If the power and memory LED do not return to solid on, power off the system to
remove the memory box and repeat the installation.
10. Install the front bezel. For instructions, see