Installing the side cover – IBM 220 User Manual

Page 70

IBM® xSeries 220 User’s Reference

Installing the side cover

The following information describes the cover installation procedure.

Note:

The illustrations in this document might differ slightly from your hardware.

Note:

If you removed the support bracket assembly after you removed the cover,
reinstall it before you install the cover.

To install the server side cover:

1. Clear any cables that might impede the replacement of the cover.

2. Align the bottom tabs of the side cover with the matching slots in the server

chassis; then, insert the tabs into the slots.

3. Close the cover-release latch to pull the cover forward and lock the cover in place.

4. Make sure that the stabilizing feet are rotated outward so that they properly

support the server.

5. Reconnect the external cables and cords to the server; then, plug the power cords

into electrical outlets.

Key lock

Cover-release
latch