IBM 220 - Manual (Page 120)

110 IBM® xSeries 220 User’s Reference
0x02 Explanation: Bad node address (multicast address).
Action: Make sure that the locally administered address is valid, if one is specified. The
address can not be a multicast address.
0x03 Explanation: Failed self-test.
Action: Make sure a cable is attached to the Ethernet connector. If the problem persists, call
for service.
0x0D Explanation: Could not allocate enough memory for transmit queues.
Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced.
4. Lower the resource values that apply to the transmit queue.
0x0E Explanation: Could not allocate enough memory for receive queue.
Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced.
4. Lower the resource values that apply to the receive queue.
0x0F Explanation: Could not allocate enough memory for other structures.
Action:
1. From the Windows NT desktop, select Start -> Control Panel -> Networks -> Adapters.
2. Select your IBM Ethernet adapter from the list.
3. Select Properties -> Advanced.
4. Lower the value for the resource named in the message.
0x10 Explanation: Did not find any Ethernet controllers.
Action: Using the Configuration/Setup Utility, make sure that Ethernet is enabled.
0x11 Explanation: Multiple Ethernet controllers found, but none matched the required ID.
Action: Using the Configuration/Setup Utility, make sure that Ethernet is enabled.
0x13 Explanation: Did not find any Ethernet controllers that matched the required subven/subdev.
Action: Using the Configuration/Setup Utility, make sure that Ethernet is enabled.
0x16 Explanation: Single adapter found but multiple instances tried to load.
Action: Using the Configuration/Setup Utility, make sure that Ethernet is enabled, and that
the slot containing the IBM Netfinity 10/100 Ethernet Adapter or the IBM 10/100 EtherJet™
PCI adapter is enabled.
0x17 Explanation: Slot parameter not specified in the registry.
Action: Remove the adapter driver and reinstall it. If the problem persists, call for service.
All other 4-
character
hexadecimal
codes Action: Call for service.
Error code (hex) Description
Table 19. NDIS (Windows NT or Windows 2000) driver messages for the Ethernet
controller