IBM 220 - Manual (Page 100)

90 IBM® xSeries 220 User’s Reference
Diagnostic error message tables
The following tables provide descriptions of the error messages that might appear
when you run the diagnostic programs.
Attention: If diagnostic error messages appear that are not listed in the following
tables, make sure that your server has the latest levels of BIOS, ServeRAID, and
diagnostics microcode installed.
Code Function Result Text message Action
001 Core system Failed Processor board, ECC Test Call for service.
System board
005 Video port Processor and system boards
011 Serial port Integrated serial port
014 Parallel port Integrated parallel port
015 USB interface Aborted Can NOT test USB interface while it is in use.
Note: If you have a USB keyboard or mouse
attached, you cannot run the diagnostic
program for the USB interface.
1. Turn off the server.
2. Replace the USB
keyboard and
mouse with a
standard keyboard
and mouse.
3. Turn on the server.
4. Run the diagnostic
test again.
5. If the test still
aborts with no USB
devices attached,
follow Failed action
below.
Failed System board Call for service.
020 PCI interface Failed System board Call for service.
030 SCSI interface Failed SCSI adapter in slot n failed register/counter/ power
test
(where n is the slot number of the failing adapter)
Refer to the information
provided with the
adapter for instructions.
If the problem persists,
call for service.
SCSI controller on system board failed
register/counter/power test Call for service.