IBM B50 - Manual (Page 83)

Checkpoint
(hex) Description Repair Action
E170 Start of PCI Bus
Probe See “Unresolved problems” on page 3-26
E171 Executing PCI-Delay
function See “Unresolved problems” on page 3-26
E172 First pass PCI
device probe See “Unresolved problems” on page 3-26
E174 Establish host
connection Refer to “Boot Problems or Concerns” on page 3-27
for some general information concerning network
booting.
E175 BootP request Refer to “Boot Problems or Concerns” on page 3-27
for some general information concerning network
booting.
1. Power Off, then Power On and retry the boot
operation.
2. Verify the network connection
3. Have network administrator verify the server
configuration for this client.
E176 TFTP file transfer See “Unresolved problems” on page 3-26
E177 Transfer failure due
to TFTP error
condition See “Unresolved problems” on page 3-26
E178 Create PCI token
ring node See “Unresolved problems” on page 3-26
E17B Processor frequency
measurement 1. Replace battery, restore NVRAM data(passwords,
startup data)
2. Replace I/O Planar.
E180 SP Command setup See “Unresolved problems” on page 3-26
E183 SP Post See “Unresolved problems” on page 3-26
E190 Create ISA node See “Unresolved problems” on page 3-26
E193 Initialize Super I/O See “Unresolved problems” on page 3-26
E196 Probe ISA bus See “Unresolved problems” on page 3-26
E19C Create tablet node See “Unresolved problems” on page 3-26
E19D Create nvram node See “Unresolved problems” on page 3-26
E19E RTC node creation
and initialization Refer to Error Code 28030xxx
Chapter 3. Error Code to FRU Index 3-19