IBM S544-5343-03 - Manual (Page 233)

Appendix D. Print Quality Problems
Print Is Too Light
Possible Causes Actions You Should Take Print Sample
Economy mode is set on Make sure economy mode is not set.
See “Configuration (Config) Menu” on
page 81.
Density is set too low Make sure that the density is not set
to a value less than 6. Reset it to a
higher value if necessary. See
“Configuration (Config) Menu” on
page 81.
There is moisture in the
paper Load fresh, dry paper
The toner cartridge is low
on toner Replace the toner cartridge with a
new one
The toner cartridge is
damaged Replace the toner cartridge with a
new one
Toner Spots on the Print
Possible Causes Actions You Should Take Print Sample
Paper does not meet
specification Use recommended paper
The toner cartridge is
damaged Replace the toner cartridge with a
new one
 Copyright IBM Corp. 1996, 1997 213