beautypg.com

IBM S544-5343-03 User Manual

Page 156

background image

Installing a Network Interface Card

Important

Follow the instructions for handling static-sensitive devices described on page 127.

Use the following procedure to install a Network Interface card:

1. Unpack the network interface card, and set aside the software and documentation

that arrived with the card.

2. If you are installing a token ring card, you must complete the following procedure to

set the line speed for the card. If you are not installing a token ring card, skip this
step and go to Step 3.

a. Lay the token ring card in front of you with the faceplate towards you.

b. On the right, rear side are six pins and two small jumpers.

If you are installing the card for a 4Mbps network, place a jumper over the
pins labeled 4.

136

Network Printer 17: User’s Guide