Minolta PI4700E - Manual (Page 72)

Specifying network settings from PageScope Light 3
Pi4700e 3-25
Ne
twor
k
Se
ttin
g
s
Ch
apte
r 3
TCP/IP Configuration
This screen appears when you click the TCP/IP Configuration menu on
the Network tab. It lets you change a number of network interface card
TCP/IP settings.
Password Input the password assigned to the network interface card. The
initial factory default is
sysadm . Clicking the Apply button after
inputting the wrong password displays a password error mes-
sage without changing the settings.
IP Address Input the IP address you want to assign to the network interface
card.
Subnet Mask Input the network subnet mask.
Default Gateway If the network has a router, input the IP address of the router.
Base Port Number Type in the base port number for RAW port printing. A port
number that in one greater than the base port number you
specify here is used for actual printing.
Example: Specifying a base port number of 10000 results in an
actual port number of 10001.
DHCP Checking this option sends a DHCP (Dynamic Host Configura-
tion Protocol) request whenever the network interface card is
powered up. When there is a DHCP server on the network, the
network interface card can obtain IP parameters automatically
from the server at power up.
IP Address in NVRAM When this option is checked, the network interface card uses
the IP address stored in NVRAM when the card is powered up.
Apply button Click this button to apply any settings you have input up to this
point.
Clear button Click this button to cancel any settings you have input up to this
point.