Minolta PI4700E - Manual (Page 70)

Specifying network settings from PageScope Light 3
Pi4700e 3-23
Ne
twor
k
Se
ttin
g
s
Ch
apte
r 3
3.9 Specifying network settings from PageScope Light
Access
PageScope Light for Pi4700e can be accessed directly from a Web browser.
1 Start the Web browser.
2 In the URL field, enter the IP address of the printer controller as shown
below.
http:///
(Example) When the IP address of the printer controller is
192.9.200.200:
http://192.9.200.200/
3 This causes PageScope Light for Pi4700e screen to appear.
Operation
PageScope Light for Pi4700e operation is identical to that for Internet Web
pages. Clicking a hot link jumps to the link destination, and the
Back and
Forward buttons scroll through pages backwards and forward.
Logging In to the Admin Mode
After you log in to PageScope Light in the Admin Mode, you can change
the configuration of the Digital Copier settings.
1 Type the administrator password into the Admin Password box. The
initial default administrator password is sysadm. See “Preference” for
information about how to change the password.
2 Click the Log-in button to log in to the Admin Mode.
3 When you want to log out, click the Log-out button.
✎
Note
Log out is performed automatically if no operation is performed for
more than 10 minutes.
On the Network tab, a password input text box appears on each set-
ting screen. You must be able to input the correct password in order to
change
Network tab settings. The password you should input here is
the same as the Admin Password you input on other tabs.