Sco unix – Minolta PI4700E User Manual
Page 400
UNIX Configuration
12
Pi4700e
12-49
A
ppe
ndi
x
Chap
ter
12
SCO UNIX
The installation procedure for SCO UNIX is similar to that for HP-UX. The
Network Card solution uses a network direct filter named nicfilter. The sys-
tem invokes nicfilter directly from the printer interface file.
After performing the procedure under Loading the Program, you must
configure the printer and make it known to the lp system.
1
Type the following to run the installation script:
nicinst
The script automatically downloads the appropriate Network Card util-
ities for your system and displays questions to prompt you for the in-
formation it needs.
2
Select your system you are using from the list of options that appears
and then press
.
1) AT&T/SVR4; 386
2) SCO UNIX System V
3) None of the above
3
What is the node name of the Network Card?
Input the host name recorded in
/etc/hosts
and then press
. For
example, type
printfast
.
4
What is the printer name for this Network Card-linked printer?
Type the printer name and press
.
5
Here, the script displays the information you have input up to this point.
Node name of the Printer Server Card: printfast
Printer name to be used:
The printer is attached on: PORT 1
Check these settings and make sure they are correct. If they are cor-
rect, type
yes
and press
. Otherwise, type
no
and press
.
6
Is this printer PostScript?
Type
yes
and press
if the printer is a PostScript printer. Other-
wise type
no
and press
.
Enter
Enter
Enter
Enter
Enter
Enter
Enter