GarrettCom 6K32TRC - Manual (Page 69)

Magnum 6K32T & 6K32TRC Managed Switch Installation and User Guide 05/07)
64
www GarrettCom com . .
Each port has an Full and Half Duplex (F/H) Activity, (ACT) LED indicating
packets being received and a Link (LK) LED indicating proper connectivity with the
remote device when lit
5.2.12b GBIC-LXSC Gigabit fiber (1000Mb), multi-mode SC Connector
The Magnum GBIC-LXSC is a single-mode Gigabit fiber connector equipped
with SC type connectors and can be easily snapped in and out. The Gigabit fiber ports are
most popular as server-to-switch and switch-to-switch applications. It supports cable
distances up to the IEEE 802.3z standard 1000Mbps distance limits, i.e., 10,25, 40 or
70Km at full duplex, and depend upon the Gigabit modules used.
1@ 1000Mb Fiber SC + 2@ 100Mb SC
The two Giga port has been offered as GBPM-2OTX (fiber or RJ-45), whereas the single
Gigabit module comes in flavor of G+4(10/100 RJ-45 ports) or G+2 (100Mb fiber ports)
as shown below in the above figure.
Each port has an Activity (ACT) LED indicating packets being received and a link (LK)
LED indicating proper connectivity with the remote device when lit.
5.2.13 6KM-BLNK
The 6K8-BLNK is a
blank face plate or cover plate that
must be installed in any empty
6K32T & 6K32TRC PM slot to
maintain proper cooling air flow,
safety, etc.
Two screws underneath the front panel hold the 6KM-BLNK in place.
TX RX L
ACT
F/
TX LK RX
ACT
F/
TX RX LK
ACT
F/