GarrettCom 6K32TRC - Manual (Page 22)

Magnum 6K32T & 6K32TRC Managed Switch Installation and User Guide 05/07)
17
www GarrettCom com . .
SC or single mode SC or Long Reach SC ports. For ports numbering, ports 1,3,5,7 are
copper, ports 2 and 6 are fiber, ports 4 and 8 are not present.
The four RJ-45 ports operate just like the 8-port copper module with auto-cross
(MDIX) feature to eliminate the use of cross-over cable, and the two fiber ports operate
at 100Mbps full-duplex (default). User mode control per port through the MNS software
is also the same.
On Magnum “4+2” Combo modules, there are four LED’s for each RJ-45 port,
which indicate status the same as described for the 6K8-RJ45 in Section 2.2.3 above. The
fiber port’s LEDs indicate status the same way as described for the SFF fiber modules in
Section 2.2.2 above. Color-coding on the panel of the module shows which LEDs
belong to which port.
The Magnum Combo six-port modules are also available with 4@ MTRJ
100Mb mm SFF fiber and 2@10Mb fiber mm ST ports, and with 4@ RJ45 10/100
copper and 2@10Mb fiber mm ST
ports. The
4@ RJ-45 + 2@ 10 Mb ST
operation of the SFF fiber
and the RJ-45 half of the module is
as described for those port types
above. For detailed information about 10Mb mm ST fiber half of the module, see
Section 2.2.5.
2.2.5 Four-Port 10 Mb mm Fiber ST Modules
The 4port @10Mb ST fiber modules behave the same as the 8@100Mb ST
fiber modules except for the 10Mb speed. For port numbering, ports 1, 2, 5, 6 are present,
ports 3, 4. 7, 8 are not present. The default setup on the 10Mb fiber module is half-
duplex, which allows the Magnum 6K32T & 6K32TRC Switch to connect to any 10Mb
hub or media converter or almost any other device with a 10Mb fiber Ethernet port. User
mode control per port through the MNS software is the same as the other 6K32T &
1 3 5 7
2 6 TX RX TX LK RX LK
ACT
F/H
ACT
F/H
10/100 LK
F/H ACT
2 6 T LK R
ACT
F/H
TX RX LK
ACT
F/H
TX RX LK
ACT
F/H
TX RX LK
ACT
F/H
1 5