GarrettCom 6K32TRC - Manual (Page 58)

Magnum 6K32T & 6K32TRC Managed Switch Installation and User Guide 05/07)
53
www GarrettCom com . .
connectors and configured as 10Mb Half-duplex by default for 10Mb fiber and 100Mb
Full duplex for the 100Mb fiber. The 10Mb ST-fiber ports allow the user to connect their
legacy 10Mb network to the Magnum 6K32T & 6K32TRC switch. They also provide a
convenient way for the half duplex hub to connect to the switch through 10Mb fiber
ports. Whereas the 100Mb ST module allow to connect the 100Mb demand of Switch
devices. It supports distances according to the 10Base-FL standard i.e, 2Km distance for
multi-mode fiber. (Single-mode for 10Km distance may be available as a special order).
Each port has an Activity (ACT) LED indicating packets being
received, a Link (LK) LED indicating proper connectivity with the remote device when
lit, and FDX/HDX LED indicating full-duplex mode when lit (or half-duplex if off).
5.2.2. 6KP6-RJMSC 4@10/100Mbps RJ-45 and 2@100Mb multi-mode FX-SC
“snap-in” Fiber connector
The Magnum 6KP6-
RJMSC is also a Combo 6 Port
module equipped with 4 10/100Mb
RJ-45 ports along with 2 multi-
mode 100Mbps fiber optic
transceivers all in one module. This
is similar to the 6K6-RJMST. It has
the same LEDs indicating port
activity (ACT), Link (LK), and
FDX / HDX and 10/100 operation, and the same face-plate lettering.
While the functionality of these two modules is essentially the same, the 6KP6-
RJMSC is equipped with an SC-type "snap-in" connector instead of an ST-type.
6KP6-RJMSC,
4 Port@ 10/100Mbps and 2 @100 Mb SC Fiber Port
4 FULL/HALF
1
ACTIVITY
LINK 2
4
3
3
10/100
1 3 5 7
2 6 TX RX TX LK RX LK
ACT
F/H
ACT
F/H
10/100 LK
F/H ACT
2
1