Rmtiradd, Rstip, Page | 36 – Gefen 1080P User Manual
Page 46
page | 36
RS-232 / IP Commands
Advanced Operation
#rmtiradd
The
#rmtiradd command sets the IR channel of the matrix. The specified IR channel
must match the IR channel of the included IR remote control unit. See
Syntax:
#rmtiradd param1
Parameters:
param1
IR channel
[0 ... 3]
Example:
#rmtiradd
Please wait...
Function completed
#rstip
The
#rstip command resets the IP configuration and routing state to factory-default
settings. The matrix must be rebooted after executing this command. To reset only the
routing states to factory-default settings, use the
command.
Syntax:
#rstip
Parameters:
None
Example:
#rstip
Please wait...
Function completed