Back, Page | 3 – Gefen 1080P User Manual
Page 13
Back
ID
Name
Description
1
Ref Loop
Connect a BNC cable from the Ref Loop
connector to a signal analyzer, in order to
view the signal on the Ref In connector.
2
Ref In
Connect an external (clock) reference to
genlock the picture. Bi-level (Black Burst)
and Tri-Level sync are supported.
3
In (1 - 16)
Connect an IR Extender (Gefen part no.
EXT-RMT-IREXT).
4
Out (1 - 16)
Connect 3G-SDI monitors (or other
destinations) to these ports.
5
IEC connector
Connect the included AC power cords from
these receptacle to available electrical
outlets. Each outlet should be on a separate
circuit.
6
RS-232
Connect a DB-9 cable from this port to the
RS-232.
7
Fuse drawer
Each internal power supply houses a
fuse drawer. See
instructions on changing the fuse.
8
IP control
Connect an Ethernet cable from this RJ-45
jack to a Local Area Network (LAN).
9
Grounding terminal
Connect a grounding wire from this
terminal to an approved ground path.
page | 3
Getting Started
Panel Layout
4
3
1
5
7
2
9
6
8