Gateway E-9525R - Manual (Page 67)

Replacing the system board www.gateway.com
61
Replacing the system board
To replace the system board:
1 Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2 Follow the instructions in “Opening the server case” on page 31 .
3 Remove the PCI riser assembly by following the instructions in “Installing
and removing PCI expansion cards” on page 44 .
4 Remove the fan duct and system fan cage by following the instructions
in
“Replacing system fans” on page 46 .
5 Remove the memory modules by following the instructions in “Installing
memory” on page 40 .
6 Remove the heatsinks and processors by following the instructions in
“Replacing or adding a processor” on page 49 .
7 Disconnect all cables from the system board, noting their locations and
orientation. (You will reconnect the cables after you install the new board.)