Gateway E-9525R - Manual (Page 63)

Installing and removing an optional mezzanine board www.gateway.com
57
4 Align the holes on one side of the board with the plastic standoffs (1) and
align the other side with the mezzanine board slot (2).
5 Push down on the board (3) to seat it in the mezzanine board slot and onto
the plastic standoffs until the retaining tabs snap into place.
6 Replace the PCI riser card assembly by following the instructions in
“Installing and removing PCI expansion cards” on page 44.
7 Follow the instructions in “Closing the server case” on page 32 .
To remove an optional mezzanine board:
1 Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2 Follow the instructions in “Opening the server case” on page 31 .
3 Remove the PCI riser assembly by following the instructions in “Installing
and removing PCI expansion cards” on page 44 .
4 Push aside the plastic retaining tabs (1) and pull the mezzanine board (2)
out of the mezzanine board slot.
5 Replace the PCI riser card assembly by following the instructions in
“Installing and removing PCI expansion cards” on page 44.
6 Follow the instructions in “Closing the server case” on page 32 .
2
3