Gateway E-9525R - Manual (Page 24)

CHAPTER 2: Setting Up Your Server www.gateway.com
18
Removing the server from a cabinet
To remove the server from a cabinet:
Warning
Screws are required to support the front
of the server. You must support the server
while removing the front screws and
while sliding the server off the cabinet
rails. If the server is not supported,
damage to the server or injury may result.
1 Remove the thumbscrews through the handles that hold the server in the
cabinet.
2 While supporting the server, slide the server out from the cabinet.
Starting your server
Before you start your server for the first time:
■ Make sure that the server and monitor are plugged into a power outlet
or surge protector and that the surge protector (if you are using one) is
turned on.
Caution
When you connect peripheral devices to
the server, make sure that your server and
devices are turned off and the power
cords are unplugged.
■ Make sure that all cables are connected securely to the correct ports and
jacks on the back of the server.
To start the server:
1 Turn on any peripheral devices connected to the server.
2 Press the power button (1). The Power LED (2) lights.