Gateway E-9525R - Manual (Page 44)

CHAPTER 4: Installing Components www.gateway.com
38
6 Make sure that the tray’s release lever is open, then slide the new drive
fully into the empty hot-swap drive bay.
7 Push the lever back into place, then turn the lock clockwise to secure the
hard drive in the bay.
8 Reinstall the bezel, if required, by snapping it into place on the front of
the chassis.
Removing and installing a diskette drive
To remove and install a diskette drive:
Caution
The diskette drive is not hot-swappable.
Before installing or removing the drive,
make sure that power is turned off and
the power cord is unplugged.
1 Follow the instructions in “Preventing static electricity discharge” on
page 30 . Make sure that you turn off the server, then unplug the power
cord(s) and all other cables connected to the server.
2 Unlock the bezel (if necessary) and remove it by pulling it from the chassis.
3 Follow the instructions in “Opening the server case” on page 31 .
4 Disconnect the USB cable from the diskette drive.
5 Lift the blue locking tab on the back of the diskette drive tray, then push
the drive tray out the front of the media cage.
Blue locking tab