Gateway E-9525R User Manual
Page 21
Mounting your server into a cabinet
www.gateway.com
15
6
Attach one mounting nut to each of the two back cabinet posts where you
plan to install the server.
Warning
You must support the server while
installing or removing the front and back
mounting screws. If the server is not
supported, damage to the server or injury
may result.
7
Hold the server in place in the cabinet and swing the hinged back rail
mounting brackets into alignment with the mounting nuts, then secure
the back in place with two mounting screws (one on each side).
Back cabinet post
Mounting nut
Hinged back rail
mounting bracket
Mounting screw