beautypg.com

Replacing the hot-swap backplane – Gateway E-9525R User Manual

Page 60

background image

CHAPTER 4: Installing Components

www.gateway.com

54

Replacing the hot-swap backplane

Caution

The hot-swap backplane is not

hot-swappable. Before removing or

replacing the backplane, you must first

turn off the server and all peripheral

devices attached to the server, and

remove the AC power cord(s) from the

power supply or wall outlet.

To replace the hot-swap backplane:

1

Follow the instructions in

“Preventing static electricity discharge” on

page 30

. Make sure that you turn off the server, then unplug the power

cord(s) and all other cables connected to the server.

2

Unlock the bezel (if necessary) and remove it by pulling it straight off the
front of the server.

3

Follow the instructions in

“Opening the server case” on page 31

.

4

Remove all of the hot-swap drive carriers from the server and make note
of which bay you remove each drive from. For instructions, see

“Removing

and installing a hard drive” on page 37

.

5

Remove the system fans and fan duct by following the instructions in

“Replacing system fans” on page 46

.

6

Disconnect all cables from the backplane.

7

Pull the backplane bracket and backplane (1) out of the chassis.

Caution

Pressing or pulling on any components

on the backplane could result in damage

to the backplane.

Caution

Make sure you do not pinch, bind, or

damage any cables as you install the

backplane.

8

Press the release tab (2) on the backplane bracket and push the backplane
to the left (3).

9

Pull the backplane from the backplane bracket.