Replacing the power distribution board – Gateway 7250R User Manual
Page 60
Replacing the power distribution board
53
Replacing the power distribution
board
The power distribution board is beside the power supply and serves to separate
the power produced by the power supply into the voltages needed by the
various internal components.
To replace the power distribution board:
1
Turn off the system and disconnect the power cord and external
peripherals.
2
Open the case. (See “Opening the case” on page 18 and “Preventing static
electricity discharge” on page 17.)
3
Remove the power supply as described in “Replacing the power supply”
on page 51.
4
Unplug the cables that connect the power distribution board to other
system components. Note the location and orientation of each cable
before you remove it.
5
Remove the four screws that secure the board to the chassis, then remove
the power distribution board.
Screws
8506162.book Page 53 Wednesday, May 10, 2000 10:21 AM
- E-2300 (134 pages)
- E-4100 (144 pages)
- ALR 7300 (138 pages)
- E-4650 (134 pages)
- E-6300 (136 pages)
- E-9232T (96 pages)
- 610 (108 pages)
- ProfileTM 5 (292 pages)
- Profile 6 (130 pages)
- E SERIES E-6000 (190 pages)
- SZSL95IN0XXXXXXXX (132 pages)
- 8400 (34 pages)
- DX4800 (94 pages)
- GR380 F1 (17 pages)
- MAN FX510 (150 pages)
- GM5688E (140 pages)
- GR585 F1 (14 pages)
- 6400 (148 pages)
- GM5478 (2 pages)
- 7400 (156 pages)
- E-5250 (46 pages)
- FX6710 (1 page)
- E-9425R (118 pages)
- ALR 7200 (134 pages)
- FX542X (154 pages)
- 7250R (26 pages)
- DX430X (96 pages)
- 8450R (4 pages)
- 8450R (172 pages)
- 7450R (124 pages)
- E-5400 (130 pages)
- E-5200 (46 pages)
- PC (110 pages)
- GR160 F1 (14 pages)
- ALR 8300 (128 pages)
- eMachine 3 (96 pages)
- 9415 (188 pages)
- 980 (131 pages)
- 9210 (106 pages)
- E1400 (136 pages)
- FX542XT (94 pages)
- E3400 (126 pages)
- Media Center (28 pages)
- MT-6733 (3 pages)