Gateway 7450R - Manual (Page 87)

Troubleshooting 79
7
Troubleshooting
Introduction
If the server does not operate correctly, re-read the instructions for the
procedures you have performed. If an error occurs within an application, refer
to the documentation supplied with the software. This section identifies
solutions to some possible problems.
Troubleshooting checklist
Before turning on the system, make sure that:
■ The power cord is connected to the power connector and an AC outlet.
■ The AC outlet is supplying power.
■ If a power strip is used, it is turned on.
■ If the power supply has a voltage selection switch, that the voltage
selection switch reflects the proper voltage.
Verifying your configuration
If the server is not operating correctly, the BIOS may contain an invalid
configuration parameter. Open the BIOS Setup utility and check your
configuration settings. (See “About the BIOS Setup utility” on page 61.)
8507328.book Page 79 Thursday, February 15, 2001 11:28 AM