Gateway 7450R - Manual (Page 39)

Replacing and Adding Internal Devices 31
4 Align the drive carrier with the slots at the sides of the drive bay. Leave
the retention lever in the open position.
5 Push the drive all of the way into the drive bay until the connector at
the back joins with the corresponding connector on the SCSI backplane,
then firmly close the lever.
6 Run any necessary utilities to setup the new drive. See the utility software
documentation for details.
Memory
Four DIMM sockets on the system board support up to 4.0 Gigabytes (GB) of
PC/133 SDRAM.
The DRAM DIMMs supported by the system board conform to the following
standards:
■ 128 MB, 256 MB, 512 MB, and 1024 MB ECC DIMMs
■ PC/133-compliant, registered, ECC SDRAM
■ 128 MB minimum system memory
■ 4.0 GB maximum system memory
When you select and install DIMMs, keep the following in mind:
■ Do not use unbuffered DIMMs.
■ Memory should be added in order, from DIMM 1 to DIMM 4.
■ There can be no empty slots between installed DIMMs.
■ No jumper settings are required for the memory size or type because the
BIOS automatically detects this information.
Important Gateway recommends that you purchase memory
upgrades through Gateway sales. An incorrect memory
match may adversely affect the performance of the server.
8507328.book Page 31 Thursday, February 15, 2001 11:28 AM