Gateway 7450R - Manual (Page 22)

14 Gateway 7450R Server System Manual
If you need to return to the previous dialog box to change any of your
entries, click
Back .
4 Restart the server. The setup is complete.
Turning off the server
Every time you turn off the server, shut down the operating system first. You
may lose data if you do not follow the proper procedure.
To turn off the server in Windows NT:
1 Click Start , then select Shut down the computer? , then Shut Down .
2 Click OK . The operating system shuts down. When you see a message
saying It is now safe to turn off your computer , turn off the server by pressing
the power button.
By default, you must hold the power button in for four seconds to turn
the server off. BIOS Setup provides an option to set the power button to
turn the power off immediately when pressed.
3 Turn off the monitor and peripherals.
Important For all operating systems, refer to the appropriate
operating system software manual for specific instructions.
Caution When you turn the server off, some electric current still
flows through it. Before opening the server case or
connecting or removing any peripherals, turn off the server,
then unplug the power cord.
Important For other operating systems, such as Windows 2000 or
Novell Netware, refer to the appropriate operating system
software manual for specific instructions. Some operating
systems will bypass the power button and turn the server
off under software control.
8507328.book Page 14 Thursday, February 15, 2001 11:28 AM