Installing a cd drive – Gateway 7450R User Manual
Page 32
24
Gateway 7450R Server System Manual
Installing a CD drive
The CD drive bay is in the center of the front panel. If the server did not
include a CD drive, a blank or “dummy” unit occupies the bay and must be
removed.
To install your CD drive assembly:
1
Turn off the system and disconnect the power cord and all other external
peripheral devices.
2
Open the case. See “Opening the case” on page 18 and “Preventing static
electricity discharge” on page 17.
3
Remove the two screws that secure the “dummy” unit to the drive bay.
4
Slide the “dummy” unit back slightly to disengage the hooks on the drive
bay from the slots on the bracket, then pull the “dummy” unit out of
the chassis.
Important
The CD drive assembly should include the bracket and
small circuit board. If it does not, contact Client Care.
“Dummy” unit
8507328.book Page 24 Thursday, February 15, 2001 11:28 AM
- E-2300 (134 pages)
- E-4100 (144 pages)
- ALR 7300 (138 pages)
- E-4650 (134 pages)
- E-6300 (136 pages)
- E-9232T (96 pages)
- 610 (108 pages)
- ProfileTM 5 (292 pages)
- Profile 6 (130 pages)
- E SERIES E-6000 (190 pages)
- SZSL95IN0XXXXXXXX (132 pages)
- 8400 (34 pages)
- DX4800 (94 pages)
- GR380 F1 (17 pages)
- MAN FX510 (150 pages)
- GM5688E (140 pages)
- GR585 F1 (14 pages)
- 6400 (148 pages)
- GM5478 (2 pages)
- 7400 (156 pages)
- E-5250 (46 pages)
- FX6710 (1 page)
- E-9425R (118 pages)
- ALR 7200 (134 pages)
- FX542X (154 pages)
- 7250R (135 pages)
- 7250R (26 pages)
- DX430X (96 pages)
- 8450R (4 pages)
- 8450R (172 pages)
- E-5400 (130 pages)
- E-5200 (46 pages)
- PC (110 pages)
- GR160 F1 (14 pages)
- ALR 8300 (128 pages)
- eMachine 3 (96 pages)
- 9415 (188 pages)
- 980 (131 pages)
- 9210 (106 pages)
- E1400 (136 pages)
- FX542XT (94 pages)
- E3400 (126 pages)
- Media Center (28 pages)
- MT-6733 (3 pages)