Gateway E-5400 - Manual (Page 34)

The system board 27
2 Holding the system board by the top and bottom edges, place it in the
case by aligning the mounting holes on the board with the stand off
(threaded) and stand off retention hooks on the right side of the case.
3 Holding the system board in place, tighten the retaining screw on the
right rear of the case.
4 Replace the retention screw previously removed from the system board,
then tighten the screw until the board is secured.
5 Reconnect peripherals, the modem cord, and the power cord, then turn
on the system.
05030.book Page 27 Monday, November 22, 1999 8:23 AM