FARGO electronic C30 User Manual

Page 4

RESTRICTED USE ONLY

Fargo Electronics, Inc.

Persona C30 Card Printer User Guide (Rev. 2.2)

Resolving a No Ribbon Installed Error________________________________________________ 4-22

Resolving a Invalid Ribbon Error____________________________________________________ 4-24

Resolving a Wrong Ribbon Error ____________________________________________________ 4-26

Resolving a Card Jam Error ________________________________________________________ 4-28

Resolving a Headlift Motor or Sensor Error____________________________________________ 4-30

Resolving the Cover Open Error Message _____________________________________________ 4-32

Resolving the Blank Output issues ___________________________________________________ 4-33

Flipper Table Module Assembly Problems _______________________________________________ 4-36

Resolving the No Flipper Table Module problem _______________________________________ 4-36

Resolving the Flipper Jam Error_____________________________________________________ 4-37

Diagnosing Image Problems __________________________________________________________ 4-39

Resolving the Pixel Failure problems _________________________________________________ 4-39

Resolving the Card Surface Debris problems ___________________________________________ 4-40

Resolving the Incorrect Image Darkness problems ______________________________________ 4-41

Resolving Ribbon Wrinkle problems _________________________________________________ 4-43

Resolving the Excessive Resin Printing problems _______________________________________ 4-45

Resolving the Incomplete Resin Printing problems ______________________________________ 4-47

Resolving the Image Placement problems _____________________________________________ 4-48

Resolving the Poor Image Quality problems ___________________________________________ 4-51

Running the Self Test _______________________________________________________________ 4-52

Running the Standard Self Test Print _________________________________________________ 4-53

Running the Magnetic Self Test (HiCo Only) __________________________________________ 4-54

Section 5: Printer Adjustments _______________________________________________ 5-1

Table of Contents ___________________________________________________________________ 5-1

Safety Messages (review carefully)______________________________________________________ 5-4

C30 Print Driver Options _____________________________________________________________ 5-5

Reviewing C30 Printer Drivers ______________________________________________________ 5-5

Using the Card tab (Persona C30) _______________________________________________________ 5-6

Adjusting the Card Size Option ______________________________________________________ 5-6

Adjusting the Orientation Option _____________________________________________________ 5-7

Selecting the number of copies_______________________________________________________ 5-8

Using the Diagnostics button under the Card tab _________________________________________ 5-9

Using the Clean Printer Option______________________________________________________ 5-10

Using the Test Print button _________________________________________________________ 5-12

Using the About button____________________________________________________________ 5-13

Using the Device Options tab (C30) ____________________________________________________ 5-14

Reviewing the Device Options tab ___________________________________________________ 5-14

Adjusting the Ribbon Type option ___________________________________________________ 5-15

Selecting the Auto Ribbon Select option ______________________________________________ 5-16

Using the new Printer Driver (Version 2.1.5)___________________________________________ 5-17

Changing the Color Profile Selection for the C30 _______________________________________ 5-18

Adjusting the Color Matching option _________________________________________________ 5-20

Adjusting for the Resin Dither ______________________________________________________ 5-21

Using the Print Both Sides option____________________________________________________ 5-22

Using the Split 1 Set of Ribbon Panels option __________________________________________ 5-23

Using the Print Back Side First option ________________________________________________ 5-24

Using the Print Back Side Only option________________________________________________ 5-25

Using the Rotate Front 180 Degrees or Rotate Back 180 Degrees options ____________________ 5-26

Using the Disable Printing option____________________________________________________ 5-27

Using the Image Color tab (C30) ______________________________________________________ 5-28

Using the Resin Heat (K) option (Front and Back) ______________________________________ 5-29

Using the Overlay Heat (O) option___________________________________________________ 5-30

Using the Color Matching option and Default button_____________________________________ 5-31

Using the Calibrate tab (Persona C30) __________________________________________________ 5-32