FUJITSU SPARC Enterprise Server M3000 - Manual (Page 74)

4-6 SPARC Enterprise M3000 Server Service Manual • March 2012
1. From the Oracle Solaris OS, type the cfgadm command to obtain the FRU
status.
2. Stop the application from using the FRU and disconnect the FRU from the
Oracle Solaris OS.
The READY LED (green) of the HDD goes off.
3. Type the cfgdevice -c unconfigure command to disconnect the FRU from
the Oracle Solaris OS.
4. Type the cfgadm -x command to confirm that the CHECK LED blinks.
The Ap_Id is shown in the output of cfgadm (for example, disk#0).
The CHECK LED (amber) of the HDD blinks.
5. Type the cfgadm command to verify that the FRU has been disconnected.
The disconnected FRU is displayed as being unconfigured.
4.3.2 FRU Removal and Replacement
After the disconnection of a FRU from a domain, the same procedure as that for Hot
Replacement/Hot Addition applies. See
Section 4.4, “Hot Replacement/Hot
Addition” on page 4-7 .
4.3.3 Configuring a FRU in a Domain
This section explains the procedure for active replacement/installation by using
Oracle Solaris OS commands. For information on using the XSCF command, see
Section 4.4, “Hot Replacement/Hot Addition” on page 4-7 .
# cfgadm -a
# cfgadm -c unconfigure Ap_Id
# cfgadm -x led=fault, mode=blink Ap_Id
# cfgadm -a