FUJITSU SPARC Enterprise Server M3000 - Manual (Page 127)

Chapter 9 Replacement and Installation of a Hard Disk Drive (HDD) 9-7
Note – In a nonmirrored configuration, if you have a backup copy of data which is
made in advance, restore it as required.
9.4.2 Hot Replacement
1. Start the domain.
See Section 4.5.3, “Powering on the Server” on page 4-13 . Connect the power
cords to power outlets and perform the subsequent steps.
2. Verify the state of the LED indicator of the hard disk drive.
For information on the LED status, see TABLE 2-3 to TABLE 2-5 .
9.4.3 Cold Replacement
1. Power on the Server.
See Section 4.5.3, “Powering on the Server” on page 4-13 .
2. Check the hardware.
This procedure includes the steps of running a program to verify that all the
components have been remounted and to start the Oracle Solaris OS.
For details, see Section 4.5.4, “Verifying the Hardware Operation” on page 4-15 .