FARGO electronic DTC500 User Manual

Page 292

RESTRICTED USE ONLY

Fargo Electronics, Inc.

DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)

292

Installing the Sensor Holder (continued)

Step

Procedure

Seat the upper portion along the black Card Guide. (Note: Be sure it is fully
seated.)

Tighten the Plastitie screw (F000177) into the Sensor holder, as shown below.

Caution: Do not overtighten. Do not use a power driver for this

process. Hand tighten only.

Lower the Print Arm.

Re-install the Card Output Hopper back into its position.