FARGO electronic DTC500 User Manual

Page 202

Text mode
Original mode

RESTRICTED USE ONLY

Fargo Electronics, Inc.

DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)

202

Using the Overlay/Print Area (continued)

Step

Procedure

When the card grid is first activated, a small black square will appear at its
default size of .2" x .2"/5mm x 5mm and at its default location in the lower left-
hand corner (0,0). (Note: This square represents the first defined area.)



Determine the area size by actually printing a card and looking at it in the

same orientation as when it exits the Printer.

Measure the total size of the desired area and enter those dimensions into the
Dimension boxes. (Note: The minimum size an area is .2" x .2"/5mm x 5mm.)

Continued on the next page