FARGO electronic DTC500 - Manual (Page 112)

RESTRICTED USE ONLY Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0) 112
Resolving a Program Exception Error
Symptom: An error has occurred in the Printers Firmware and a Program Exception Error.
Step Procedure
1 Restart the Printer and attempt to print the card again.
a. If no Error is displayed, continue printing.
b. If a Program Exception is displayed again, continue to step 2.
2 Reload the Firmware. See the Updating the Printer's Firmware in Section 10,
page 275.
3 Replace the Main Board. See the Replacing the Main Board procedure in
Section 5, page Error! Bookmark not defined..