Rubber pads through baseplate – FARGO electronic DTC500 User Manual
Page 148
RESTRICTED USE ONLY
Fargo Electronics, Inc.
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
148
Attaching the Card Lamination Module (continued)
Step
Procedure
6
Set the Printer completely into the lamination module's Baseplate. (Note: The
rubber pads on the bottom of the Printer will rest securely in the holes in the
lamination module's Baseplate when the Printer is seated properly.)
Continued on the next page
Rubber pads
through Baseplate