FOCUS Enhancements Bridge/Router MX-4DV - Manual (Page 98)

MX-4 DV U SER G UIDE C HAPTER 9 94
6 Repeat steps 3 through 5 until your composition is complete.
7 Use the PLAY button or T - BAR to send your composition to the program output.
P
LAYING THE
C
OMPOSITION
To play a composition on the output device:
•
Press PLAY or use the T - BAR .
Moving the T - BAR from the bottom-to-top in its slot transitions the composition to Program.
Moving it from top-to-bottom dissolves it out.
Pressing PLAY produces a cut from the CURRENT source to the composed screen — using the
T - BAR produces a dissolve. Pressing PLAY or using the T - BAR again lets you switch back and forth
between the CURRENT source and the composed image.
To reposition the T - BAR , hold down SHIFT while moving it. Holding down the SHIFT button tempo-
rarily disables the T - BAR .
NOTE
If you cut to any source or exit from Compose mode, your composed screen will be lost and cannot
be recovered.
E
XITING FROM
C
OMPOSE
M
ODE
Remember, if you do not record your composed image to the output device before exiting Com-
pose mode, your composed image will be lost and cannot be recovered.
To exit from Compose mode, press COMPOSE .