FOCUS Enhancements Bridge/Router MX-4DV - Manual (Page 89)

PIP S F OREGROUND T ILE
85
Manipulating the
Foreground Tile
This section explains how to change the position, size, shape, and so forth of the foreground tile. In
each case, do the steps after pressing
PIPS , as described in the preceding steps. You can do any of
these steps while the PIP plays on the Output.
Table 9: Manipulating PIPs Tiles
T O CHANGE TILE … U SE OR PRESS … N OTES …
Position
JOYSTICK Moves the tile and its mask around the screen.
OK + JOYSTICK Moves the tile around the screen.
Size (Resizing the tile normally distorts the image it contains.)
T - BAR Resizes the foreground tile and its mask. Use
the
T - BAR to manually zoom the image.
OK + T - BAR Resizes the foreground tile.
UP ARROW Increases the height of the foreground tile and
its mask.
DOWN ARROW Decreases the height of the foreground tile and
its mask.
RIGHT ARROW Increase the width of the foreground tile and its
mask.
LEFT ARROW Decrease the width of the foreground tile and its
mask.
SHIFT + FLIP
▲ Snaps the PIP tile and its mask to the normal
aspect ratio base on the current horizontal
dimensions.
SHIFT + FLIP
▼ Snaps the PIP tile and its mask to the normal
aspect ratio base on the current vertical dimen-
sions.
SHIFT +0 (zero) Restores the PIP tile to the default size, shape,
and position.
Shape
SHAPES Cycles through available shapes for foreground
tile.
SHIFT + SHAPES Cycles backward through shapes.
n Applies a specific shape to the tile, where n cor-
responds to the numbers shown in the shapes
following this table.